頂部結構：快速軟簾門(快速卷簾門)的傳動機構安裝在門洞頂部機箱內，機箱由厚2mm厚鍍鋅鋼板制作而成兩端端由厚6mm鋼板制作，在端板上設有安裝卷軸軸承，驅動電機，平衡系統構件的安裝座和安裝孔，鋼板表面經噴塑處理成客戶要求的色彩。卷軸安裝于機箱內，由卷筒、軸端、軸承座等組成。卷筒尺寸根據門洞高、寬尺寸經過計算，選擇合理尺寸，在這個門上，卷筒直徑為219mm。
Top structure: the transmission mechanism of the fast soft shutter door (fast rolling shutter door) is installed in the chassis at the top of the door opening. The chassis is made of 2mm thick galvanized steel plate, and the two ends are made of 6mm thick steel plate. The end plate is equipped with mounting roller bearings, driving motors, mounting seats and mounting holes for balancing system components. The surface of the steel plate is sprayed with plastic to the color required by customers. The reel is installed in the chassis and is composed of drum, shaft end, bearing seat, etc. The drum size is calculated according to the height and width of the door opening, and the reasonable size is selected. On this door, the drum diameter is 219mm.
導槽箱：導槽箱由厚2mm鍍鋅鋼板制作，立于門洞二側固定于墻面，機箱則置于導槽箱頂部通過螺栓與導槽箱及墻面固定。導槽箱導槽二側固定有密封毛條，以保證的密封要求，在導槽箱的底部離地約1m高位置，則預留有紅外線監測器的安裝位置。導槽箱經噴塑處理，與機箱同色，導槽里部的毛刷抵住簾布以限制簾布不會脫離導槽，這樣當車子撞到門的時候，門簾會脫離導槽，從而避免門體損壞。

Guide box: the guide box is made of 2mm thick galvanized steel plate, standing on the two sides of the door opening and fixed on the wall. The chassis is placed on the top of the guide box and fixed with the guide box and the wall through bolts. Sealing wool strips are fixed on both sides of the guide groove of the guide groove box to ensure the sealing requirements of the. At the bottom of the guide groove box about 1m above the ground, the installation position of infrared monitor is reserved. The guide slot box is sprayed with plastic and has the same color as the chassis. The brush in the guide slot butts the cord fabric to limit that the cord fabric will not separate from the guide slot. In this way, when the car hits the door, the door curtain will separate from the guide slot, so as to avoid damage to the door body.
簾布：簾布分段制作，每段高度約為700mm左右，各段簾布通過的鋁質抗風條聯接成一整體簾布，簾布厚1.2mm,具有強度高、抗沖擊、不易刺穿等優點。還可選用δ=2mm的透明PVC材料制作簾布或部份選用透明PVC材料制作簾布，以便觀察軟簾門二側的情況，在簾布的底部設有鋁質底梁，及防撞軟袋簾布的頂部通過螺釘和壓條固定在卷筒上。
Cord fabric: the cord fabric is made in sections, and the height of each section is about 700mm. The aluminum wind resistant strip of each section of cord fabric is connected into an integral cord fabric. The cord fabric is 1.2mm thick, which has the advantages of high strength, impact resistance and not easy to puncture. Optional δ= 2mm transparent PVC material is used to make cord fabric or part of the cord fabric is made of transparent PVC material to observe the situation on both sides of the soft curtain door. Aluminum bottom beam and anti-collision soft bag are set at the bottom of the cord fabric, and the top of the cord fabric is fixed on the drum through screws and strips.
驅動裝置：通過減速馬達直接驅動軟簾門轉軸，根據提升速度的要求選用不同速比的減速器，達到所要求的提升速度，速度可達到80cm/s以上。控制線路采用變頻控制，使簾布運行時做到緩起動緩?fù)Ｖ梗⒖墒购煵嫉轿蛔酝＃霸谶\(yùn)行過程中停止運動。
Driving device: the soft curtain door rotating shaft is directly driven by the reduction motor, and the reducer with different speed ratio is selected according to the requirements of lifting speed to achieve the required lifting speed, which can reach more than 80cm / s. The control circuit adopts frequency conversion control to make the cord start and stop slowly during operation, and make the cord stop automatically in place and stop moving during operation.
控制：軟簾門設有控制箱，可在控制箱操作“開”“停”“關”并可在控制箱的另一側墻面設控制按鈕操作“開”“停”“關”。可根據需要選配遙控操作和雷達探測或地磁感應自動開關門，在門洞二側設有紅外線監測裝置，當門體運動時有障礙物穿越門洞時，簾布運動將停止，或回復到開門狀態。
Control: the soft curtain door is equipped with a control box, which can operate "on", "stop" and "off" in the control box, and a control button can be set on the wall on the other side of the control box to operate "on", "stop" and "off". Remote control operation, radar detection or geomagnetic induction automatic door opening and closing can be selected as required. Infrared monitoring devices are set on both sides of the door opening. When an obstacle passes through the door opening when the door body moves, the cord movement will stop or return to the open state.
以上就是濟南卷簾門 給大家分享的主要內容，更多的精彩內容請大家繼續關注我們：http://www.santoncc.cn
The above is the main content shared by Jinan roller shutter door. Please continue to pay attention to us for more wonderful content: http://www.santoncc.cn