市面上遙控卷簾門的廠家越來越多，為了成交客戶，一些廠家不得不打起了戰，但是，沒有一個廠家愿意做虧本買賣，以于以次充好，那么這些遙控卷簾門會出現哪些問題呢，不妨來看一看。

There are more and more manufacturers of remote control roller shutter doors in the market. In order to clinch a deal with customers, some manufacturers have to fight a price war. However, none of the manufacturers are willing to do business at a loss, so that inferior products are replaced by good ones. What problems will occur with these remote control roller shutter doors? Let's have a look.

凹槽接口處，由于遙控卷簾門在實際使用過程中，不停地上下運動，當門板著地時，整個門體有向下的壓力，低質的遙控卷簾門門板凹槽處會被頂裂脫開，致使門板損壞。

At the groove interface, because the remote control rolling shutter door keeps moving up and down in the actual use process, when the door plate touches the ground, the whole door body has downward pressure, and the groove of the low-quality remote control rolling shutter door plate will be cracked off, causing damage to the door plate.

預埋鐵在聚氨酯發泡劑的壓力下錯位，安裝時不易找到預埋鐵，無法將鉸鏈固定螺栓打準，致使多層折疊處安裝不穩健。

The embedded iron is misaligned under the pressure of polyurethane foaming agent, so it is difficult to find the embedded iron during installation, and the hinge fixing bolts cannot be aligned, resulting in unstable installation at the multi-layer fold.

常見的遙控卷簾門的門板的厚度為40mm，假定做得太厚，本錢太高，造成浪費，不做太厚，在40-50mm的基礎上，在門洞寬度大于6000mm的情況下，抗風性能差;或許有的廠家在安裝時，在門板背面增加鍍鋅鋼板捆綁的外置加強筋，用抽芯鉚釘設備固定，但效果不佳，原因是加強筋與門板的背板不能成為整體。

The thickness of the door panel of the common remote control rolling shutter door is 40mm. If it is too thick, the cost is too high, resulting in waste. It is not too thick. On the basis of 40-50mm, the wind resistance performance is poor when the door opening width is greater than 6000mm; Some manufacturers may add external stiffeners bound by galvanized steel plate at the back of the door panel during installation and fix them with pop rivets, but the effect is poor because the stiffeners and the back plate of the door panel cannot be integrated.

遙控卷簾門聚氨酯發泡劑制作時在凸槽處外溢，污染門板外表及浪費聚氨酯發泡劑材料。

Polyurethane foaming agent for remote control rolling shutter door overflows at the convex groove during production, polluting the appearance of the door panel and wasting polyurethane foaming agent materials.

濟南遙控卷簾門門板在不起抗風效果，并且不美觀，影響企業的整體形象。

Jinan remote control rolling shutter door panel has no wind resistance effect and is unsightly, which affects the overall image of the enterprise.

怎樣減少遙控卷簾門出現危險現象?

How to reduce the danger of remote control rolling shutter door?

遙控卷簾門機運行時，門下禁止站立或通行，門簾下方不得有阻礙物。在啟閉卷簾門時下面不準有人、貨物、車輛站立、通過，以防止行程開關失靈，卷簾卡死，電機受阻和發生其他事故。

When the remote control rolling shutter door machine is running, it is forbidden to stand or pass under the door, and there shall be no obstacles under the door curtain. When opening and closing the rolling shutter door, no one, goods or vehicles are allowed to stand or pass under it, so as to prevent travel switch failure, rolling shutter jamming, motor obstruction and other accidents.

合理的升降速度 能減少能源浪費與傳動部件的摩擦損耗 ，也有助于延長變頻器的的使用壽命禁止高度、寬度大于卷簾門的門框高度、寬度的貨物或車輛通過，防止撞壞門軌、門扇，影響卷簾門的正常使用和使用周期。

Reasonable lifting speed can reduce energy waste and friction loss of transmission parts, and also help to prolong the service life of the frequency converter. Goods or vehicles with height and width greater than the height and width of the door frame of the rolling shutter door are prohibited to pass through, so as to prevent damaging the door rail and door leaf and affecting the normal use and service cycle of the rolling shutter door.

卷簾門在啟閉停止過程中應具備隨位停止之功能，不應有停止而繼續下滑現象，如發生下滑距離大于50mm的情況出現，立即對遙控卷簾門控制電器和卷門機制動器進行仔細檢查修理，運行正常為止。在維修與養護快速門電機時，需要請人員負責，維修時應切斷電源，非人員不得打開電器箱，以防觸電。

The rolling shutter door shall have the function of follow-up stop in the process of opening, closing and stopping. It shall not stop and continue to slide. If the sliding distance is greater than 50mm, the remote control rolling shutter door control appliance and the rolling shutter mechanism actuator shall be carefully inspected and repaired immediately, and the operation shall be normal. When repairing and maintaining the fast door motor, it is necessary to ask professional personnel to be responsible. During maintenance, the power supply should be cut off. Non professional personnel are not allowed to open the electrical box to prevent electric shock.

以上就是問題解答的相關內容了，希望能夠幫助到大家，如對這一問題還存在任何疑問，都歡迎關注我們網站http://www.santoncc.cn并咨詢我們的工作人員，將竭誠為您服務。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.santoncc.cn And consult our staff, will serve you wholeheartedly.